Dakota Digital LAT-NR140 installation instructions Kit Includes Installation

INSTALLATION INSTRUCTIONS

LAT-NR140

LED Tail Lights for ’68-‘69 Nova

MAN#650157

Kit Includes:

Installation:

1.Remove the tail light lens.

2.Remove the light bulb.

3.Remove the original bulb connector from the back side of the housing.

4.Now is a good time to clean the lens and housing. If lenses are in bad shape a new set is recommended.

5.Insert the supplied rubber grommet into the hole where the original light socket was located. This will protect the wires from rubbing on the metal edge.

6.Make sure the stock lens gasket is removed from the housing and place the supplied drill template into the housing and drill three 3/32” holes.

7.Route the wires out through the opening of the rubber grommet. Insert the new LED assembly and secure it in place with the supplied #4 self-tapping screws. Tighten the screws down carefully to avoid stripping out the holes. Only two screws are required to secure it properly but a third is provided in case it is necessary. A machine screw (not supplied) can also be used with a nut placed on the back of the housing if desired.

8.Place the original lens gasket back into the tail light housing and replace the tail light lens. Tighten the screws down carefully.

MAN#650157