6.Insert the new LED assembly through the hole where the original bulb and connector were. Use caution when feeding the wires through to avoid damaging the wire insulation.
7.Feed the wires through the round metal spacer, with one wire going through each outer hole in the aluminum spacer. The larger diameter ring should be away from the tail light housing. Use caution when feeding the wires through to avoid damaging the wire insulation.
8.Secure the metal spacer with the supplied #6 nut.
9.Place the original lens gasket into place and replace the tail light lens. Tighten the screws down carefully.
MAN#650188
