Danby 7009REE, 6009REE Operating Instructions, Power Button On / Off FAN Speed Button High / Low

OPERATING INSTRUCTIONS

8 7 6 5

9

1 2 3

1)POWER Button: On / Off

2)FAN SPEED Button: High / Low

3)TIMER Button: When unit is operating, press TIMER to set number of hours desired until unit will shut off.When unit is in stand-by, press TIMER to set number of hours desired until unit will turn on.

Setting timer from 1-24 hours. To cancel the timer, proceed as above but set the “timer off” to zero (0) hours.

4)°C/°F Button: Press the °C/°F button to toggle between Celsius and Fahrenheit.

5)Receiving Sensor

6)SET HUMIDITY/CURRENT HUMIDITY DISPLAY: When machine is running, it displays the

4

current humidity. Press UP or DOWN buttons to select humidity setting. The humidity is adjusted in increments of 5% by each press. Adjustable range is within 30% RH to 90% RH. 10 seconds after setting humidity, the display will change back to the current humidity.

7)CURRENT TEMP/ TIMER SET DISPLAY: When machine is running, it displays the current temperature. Press the TIMER button to set the machine to shut off automatically after specified amount of time. 10 seconds after displaying the timer, the display will change back to current temperauture.

8)DEFROST LIGHT: When temperature is low, unit enters defrost mode and defrost light illuminates.

9)BUCKET FULL LIGHT: When water tank is full, bucket full light illuminates.

REMOTE CONTROL The functions work the same as your dehumidifiers touch controls.

1)Power Key: On / Off

2)Fan Speed Key: High/Low

3)On / Off Timer Key:

In running mode: Auto switch Off

In standby mode: Auto switch On

4)Temperature display selector button (Celsius / Fahrenheit): Press the°C/°F switch button to toggle between °C and °F.

5)Timer/ Temperature Buttons:

A)Used for adjusting the timer and thermostat.

B)The default display is room temperature.

C)When “+” or “-” button is pressed, the set temperature is displayed and may be adjusted. After 10 seconds the display will revert back to room temperature. The remote operates within a range of 6 meters (16.4 ft.)from the receiver located inside the main unit. Any obstruction between the receiver and remote may cause signal interference, limiting the ability to program the main unit.

This Class B digital apparatus complies with Canadian ICES-003.

1

2

3

4

5

BATTERIES: Remove the cover on the back of the remote controller and insert the batteries with the (+) and (-) poles pointing in the proper direction.

CAUTION: Use only AAA or IECR03 1.5V batteries. Remove the batteries if the remote controller is not used for one month or longer. Do not attempt to recharge the supplied batteries. All batteries should be replaced at the same time. Do not dispose of the batteries in a fire as they may explode.

4