Setting The Temperature Control
The temperature of the freezer compartment
is controlled by adjusting/setting the thermostat control knob, located on the front of the freezer cabinet
Fig. 14 | Fig. 15 |
To start the freezer and achieve maximum cooling quickly:
•Turn the temperature control knob clockwise to the furthest (maximum) setting on the darker blue (wide) section if the graduated control dial.
•Allow the freezer to turn at this setting for
•When maximum cooling is achieved, turn back the temperature control knob setting to the 2 o’clock position on the graduated blue control dial. See Fig.15.
•To turn off the freezer (no cooling) rotate the control knob to the “0” (off) position. See Fig. 14.
Care and Maintenance
Defrosting
Moisture will be introduced into the cabinet during lid openings and the addition of unfrozen food packages. The moisture will accumulate in the form of frost mostly on the upper part of the freezer liner walls.
Accumulation of frost up to 6 mm (1/4") on the liner is not harmful. However, when it becomes heavier, it should be removed as it retards cooling resulting in longer running (cycle) times. Frost may be removed with a wooden spatula or a plastic defrosting scoop by simply scraping off the accumulations from the side of the walls. Do not use any sharp instruments as this may result in damage to the liner wall and/or sealed system, voiding any and/or all warranties which may be in effect.
Under average conditions, defrosting will not be necessary more than once or twice a year.
Besides frost, food particles and other foreign substances may may accumulate and soil the liner. For proper defrosting and cleaning, the following method is recommended:
a)Unplug freezer.
b)Quickly remove all frozen food and store them in baskets, cartons or other suitable containers. Keep them well covered with blankets to avoid excessive temperature rise.
c)A kettle/pot of hot water placed in the center of the liner will greatly accelerate defrosting.
d)With the help of a wooden spatula or a plastic defrosting scoop, remove the frost and ice off the liner walls as soon as it becomes loose (approximately 15 minutes from start). Using a piece of cloth soaked in hot water, the process can be considerably accelerated. As soon as the ice has fallen to the bottom, remove it. Do not let it melt in the freezer as this will increase defrosting and cleaning time.
Cleaning
Now the liner is ready to be cleaned. Sprinkle baking soda on the bottom and walls. This will help in cleaning and odor removal. In order to retain the finish of the freezer cabinet inside and outside, wash only with warm water and mild soap, then rinse and dry. Do not use under any circumstances, a grit soap or a kitchen scouring cleanser as they tend to scratch the finish.
Electrical and Mechanical Failure
In the event of a general power failure, it is important to keep the contents of your freezer frozen. For your protection, it is recommended to locate a dealer of dry ice (solidified carbon dioxide) as soon as possible in order to know where to go in case of an emergency. Many ice cream manufacturers use dry ice and this will keep the contents of your freezer at safe temperatures until the emergency has passed.
In case of failure, it is recommended to keep the freezer well covered with blankets. This will help preserve the “cold” inside the freezer. If no help is available within 12 hours, the freezer contents should be transferred into a neighbors’ freezer (if available).
In the event of mechanical or electrical failure of the freezer, contact your dealer immediately and give him complete information of your freezer, the model number and the serial number. These are shown on the serial plate located on the rear (exterior) cabinet wall.
3