OPERATION
FEATURES OF
THE CONTROL
PANEL
KEY PAD FUNCTIONS
POWER SWITCH: Turns unit ON/OFF
MODE: Allows you to scroll through and select desired operating mode.
FAN: Select from three different fan settings; High, Medium, and Low.
AUTO-TIMER
AUTO-TIMERAuto off- With machine in running mode, press timer button to set timer control. Press 
or 
buttons to select number of hours you would like the unit to run before it automatically shuts off.
Auto on- With machine in stand by mode, press timer button to set timer control. Press 
or 
buttons to select number of hours before the unit automatically starts running in air conditionning mode.
NOTE: The time is adjustable between 1-24 hours.
TEMPERATURE Adjust:
•Used for adjusting the thermostat.
•The default display is room temperature.
•In cooling mode, when 
button is pressed, the set temperature is displayed and may be adjusted. After 15 seconds the display will revert back to room temperature. Temperature is only adjustable in cool mode.
NOTE: By pressing both 
buttons at the same time for more than 3 seconds, the display will toggle between Celsius and Fahrenheit.
STATUS DISPLAY
Warning Light
Condensed water may accumulate in the unit. If the internal tank becomes full, the Warning signal in the LCD Display will light up and the unit will not operate until the unit has been drained.
Timer & Temp. Display
Room Temp.
Temp. Set
Timer Set
MODE INDICATOR LIGHTS
Cooling Mode
When cool mode is selected, the indicator light will shine GREEN. During the cooling mode, the air is cooled and hot air is exhausted outside through the exhaust tube. Adjust fan speed to suit your desired comfort level.
Note: The air exchange h ose must vent outside the room when using cool mode.
Dehumidify Mode
When dehumidify mode is selected, the indicator light will shine ORANGE. Air is dehumidified as it passes through the unit, without being in full cooling mode. The fan will operate on med. speed. If room temperature is >25°C (77°F), fan speed can be adjusted; otherwise fan speed is fixed to “low”.
Note: The warm air exchange hose must vent inside the room when using Dehumidify Mode, not outside as it does when cooling. If the unit is vented outside, some cooling will occur.
Fan Mode
When fan mode is selected, the indicator will shine YELLOW. Air is circulated throughout the room with no cooling.
Note: The unit does not need to be vented in Fan mode.
Heating Mode
When heating mode is selected the indicator will shine RED. Heating is activated only when the ambient temperature is below 25°C (77°F).
FAN SPEED INDICATOR LIGHTS
High Fan
Medium Fan
Low Fan
NOTE: After switching the air conditioner off, you must wait 3 minutes before switching it back on again.
5
