SAFETY INSTRUCTIONS
ATTENTION
| GROUNDING INSTRUCTIONS |
| |
| This | appliance | must be grounded. | In |
| the | event of | an electrical short | circuit, |
grounding reduces the risk of electrical shock by providing an escape wire for the electrical current. This appliance is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded.
WARNING - Improper use of the grounding plug can result in a risk of electric shock. Consult a qualified electrician or serviceman if the grounding instructions are not completely understood, or if the doubt exists as to whether the appliance is properly grounded.
DO NOT USE AN EXTENSION CORD
Use an exclusive wall outlet. Do not connect your wine cooler to extension cords or together with any other appliance in the same wall outlet. Do not splice the cord.
IMPORTANT WARNING
An empty wine cooler is a very dangerous attraction to children. Remove either the gasket, latches, lids or doors from unused appliances, or take some other action that will guarantee it harmless.
DON’T WAIT! DO IT NOW!
SPECIAL INSTRUCTIONS
You must remove the bottom door support on the bottom left hand side of the unit before you can open the door. (See Fig. A)
FIG. A
INSTALLATION INSTRUCTIONS
Remove the exterior and interior packings, wipe the outside thoroughly with a soft dry cloth and the inside with a wet, lukewarm cloth. Avoid placing the cabinet in a narrow recess or near any heat source, direct sunlight, or moisture. Let air circulate freely around the cabinet. Keep the rear of the wine cooler 5 inches away from the wall.
Location
1.Select a place with a strong, level floor.2.Allow 5 inches of space between the back of the wine cooler and any adjacent wall.
3.Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating. Heat sources nearby will cause higher electricity consumption.
OPERATION
To avoid vibration, the cabinet must be set level. To start the wine cooler, turn the temperature control to the position corresponding to the desired cooling. The wine cooler temperature will vary depending on the quantity of bottles stored and on the frequency with which the door is opened.
Fig. 14 | Fig. 15 |
The temperature of the wine cooler compartment is controlled by adjusting/setting the thermostat control knob, located on the exterior rear wall of the cabinet.
To start the wine cooler and achieve maximumcooling quickly;•Turn the temperature control knob clockwise to the furthest (maximum) setting on the darker blue (wide) section of the graduated control dial.
•Allow the unit to run at this setting for•When maximum cooling is achieved, turn back the temperature control knob setting to the 2 o’clock position on the graduated blue control dial. See fig.15.
•To turn off the wine cooler, (no cooling) rotate the control knob to the “0” (off) position. See fig.14
Turn the control to the “OFF” (0) position to temporarily disconnect the cooling cycle. When the wine cooler is not to be used for a long period of time, disconnect the plug and leave the door partially open.
2