INSTALLATION INSTRUCTIONS
LOCATION
REQUIREMENTS
|
|
|
|
|
| 5 In. |
| 5 In. |
|
DO...
•Select a location with a strong, level floor.
•Allow for 5 inches of space between the back of the appliance and any adjacent wall.
•Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating; heat sources nearby will cause higher electricity consumption.
DO NOT...
•Use this appliance outdoors: This appliance is intended for household use only. Do not attempt to operate or store this appliance outdoors.
•Build this appliance into an enclosure:
This appliance is designed for a Free- Standing application only and is not intended to be
DOOR REVERSAL
INSTRUCTIONS
Door Removal
1)Unplug the wine cooler, empty all of its contents and carefully lay the unit on its back.
2)Remove the adjustable foot located beside the lower hinge assembly on the bottom right side of the cabinet (Fig. 1).
3)Unscrew the two retaining screws holding the lower hinge assembly to the bottom of the cabinet and set them aside (Fig. 2).
4)Pull the door downward until it releases from the top hinge pin (Fig. 3), and then set the door aside.
Door Reversal
5)Using a flathead screwdriver, transfer the top hinge pin from the right side of the worktop to the opposite (left) side of the worktop (Fig. 3).
6)Transfer the plastic cap located on the top left side of the door to the opposite (right) side of the door (Fig. 4).
7)Set the door onto the cabinet and push it upward until the top hinge pin is fully inserted into the opening on the top left side of the door.
8)Remove the two retaining screws on the bottom left side of the cabinet, and transfer them to opposite (bottom right) side of the cabinet (Fig. 5).
9)Insert the bottom hinge pin on the lower hinge assembly (Fig. 2) into the opening on the bottom left side of the door, and then align the door and lower hinge assembly with the cabinet.
10)Screw the lower hinge assembly (Fig.2) to the bottom of the cabinet by aligning the holes in the lower hinge assembly with the holes in the bottom of the cabinet.
11)Reinstall the adjustable foot removed in step 1 (Fig.1).
12)Ensure the door is squarely fitted to the cabinet and that all fastenings are secure. Stand the unit upright.
IMPORTANT: Allow the unit to stand upright for at least one hour prior to starting operation.
Top Hinge Pin
A. Plastic Cap
A. Top Hinge Pin
Lower Hinge Assy.
A. Hinge washer
B. Bottom hinge pin
C. Screw washers
D. Screw gaskets
E. Screws
Adj. Foot
A. Screw washers
B. Screw gaskets
C. Screws
3
