INSTALLTION INTRUCTIONS
TOOLS YOU
WILL NEED
FOR YOUR SAFETY:
While performing installations described in this section, gloves, safety glasses, or goggles should be worn.
Safety Glasses | Level |
Gloves | |
| Flashlight |
| Carpenters |
| Square |
| Measuring |
| Tape |
Drill & Hole Saw set |
PREPARING THE | ELECTRICAL REQUIREMENTS: The appliance must be connected to an |
ENCLOSURE | individual, properly grounded electrical outlet, protected by a 15 or 20 ampere circuit |
| breaker or time delay fuse. |
|
•It is recommended that you do not install the wine cooler into a corner (i.e. directly beside a wall). This is to allow the door to have a greater then 90° opening swing. A limited door swing may lead to damaging the door gasket.
•The rough cabinet opening must be on a level floor area and at least 24” deep by 24” wide. The opening should also have a height of at least 34 3/4”.
•The electrical oulet may be positioned from within either side of the adjacent cabinetry, or the rear of the shaded area (as shown in Fig E).
•If the electrical outlet is located inside the adjacent cabinetry, cut a
343/4” From
Underside
of
Countertop
to Floor
1
| ||
*if electical |
| |
outlet is in |
| |
adjacent | 24” | |
cabinetry | ||
Min. | ||
| ||
| 2” | |
Electrical Access | Cabinets | |
Square | ||
| and | |
| Plumb | |
| 6” |
24”
Fig E
3