8Installation Instructions - Integrated Application Preparing theEnclosure

FOR YOUR SAFETY:

While performing
installations described in
this section, gloves, safety
glasses or goggles should
be worn.
Tools You WillNeed
Carpenter’s
Square
Measuring
Tape
Level
Drill & Hole Saw set
Gloves
Safety Glasses
Flashlight

Electrical Requirements:

The appliance must be
connected to an individual
properly grounded electrical
outlet, protected by a 15
ampere circuit breaker or
time delay fuse.
Important: It is recommended
that you install the wine cooler in
alocation that allows the door to
have a greater then 45° opening
swing. Alimited door swing will
prevent the shelves from sliding
out as intended, and may lead
to damaging the door gasket.
•The rough cabinet opening
must be on a level floor area
and at least 24” deep*by 12-1/2”
wide. The opening should also
have a height of at least 34-1/2”.
•The electrical outlet may be
positioned from within either
side of the adjacent cabinetry,or
the rear of the shaded area (as
shown in Fig C.).
Note: If the electrical outlet is
surface mounted (not flush) within
the enclosure, the

depth

requirment for the installation
will be affected.
•If the electrical outlet is located
inside the adjacent cabinetry,cut
a1-1/2” diameter hole to admit
the power cord.
Fig C

*The listed depth requirment for the installation is assuming that the electrical outlet is located in the adja-

cent cabinetry or is flush mounted in the rear wall, not surface mounted in the enclosure.

Philips
Screwdriver