Installation Instructions
CONNECTING THE
WATER SUPPLY HOSE
Connect the water inlet hose to the connector by turning the connecting nut.
Do not unscrew the lid of the hot water connector on the water mixing valve, and then connect the other end of
Plate
Release button
Be sure a rubber ring is inside the connecting nut.
Rubber
Ring
Connecting nut
Water inlet hose
water inlet hoses to the cold connector in water mixing valve by turning the connecting nut.
Hot water |
| |
connector | Rubber | |
| Ring | |
Cold water |
| |
connector |
| |
Connecting |
| |
Nut |
| |
Water | Lid of | |
hot water | ||
inlet hose | ||
connector | ||
|
To release, turn off the water faucet and press the release button to release the pressure of water then press down the plate.
2
If you have both cold and hot water supplied, connect the inlet hose cold to cold and hot to hot.
Connect the water inlet hose to the tap connector by turning the connecting nut.
Water faucet
Rubber
ring
Connecting nut | Water |
| |
| inlet hose |
To release, turn off the water faucet and turn on the washer to run about 5 minutes and then disconnect the inlet hoses.
Unscrew the lid of the hot water connector in water mix- ing valve, and then connect the other end of water inlet hoses to the connectors in water mixing valve by turning the connecting nut.
Hot water
Cold waterconnector connector
Water inlet hose
Rubber ring
Connecting nut
Note:
1.Do not over tighten or cross thread the nut in order to prevent the elbow of the water inlet from breaking.
2.If water seeps, you should check the nut to see if there is a rubber sealed ring.
7