UNPACKING YOUR COUNTRY SMOKER
Your new Louisiana Grill “Country Smoker” may require some assembly. Please note that during shipping some movement may have taken place, so a complete visual inspection is required.
TIP Be sure to inspect entire grill after removing the protective shipping carton.
Report any damage to your local dealer immediately.
Shipping damage is not covered under warranty.
TG300 model
Tool Required:
1 - Phillips Screwdriver 5/8” socket and driver
Procedure:
You will find 4, 3” long Phillips wood screws inside securing the grill legs to the shipping crate. Back these out. Gently remove your grill from the shipping pallet and place either on a
450, 570, 680, 1070 and Whole Hog model
Procedure:
You will find the smokin grills attached to the shipping pallet using 2 x 5/8” bolts. Reach under the shipping pallet and completely back out the threaded bolts. Gently remove your grill from the shipping pallet and install the 2 threaded levellers on the bottom of the engineered legs.
PROPER COMPONENT PLACEMENT
|
|
| Proper placement is vital to proper performance. |
|
|
| During shipping and after any general movement, it is important to |
| 2 |
| inspect and ensure the proper placement of key component parts. |
|
|
| |
| 1 |
| 1. Burn Grate and Burn Pot |
|
| 3 To help in making cleaning easier, you can remove the burn grate (B) | |
|
|
| and burn pot (A). |
|
|
| Remove any debris from the burn pot area. This reduces the possibility |
|
|
| of air leaking around the bottom edges. |
1 |
|
| Line the bottom of the smoker with heavy duty aluminum foil. |
B |
| ||
|
|
| Ensure that the notched portion (C) of the Burn Pot (A) is pushed, |
|
|
| tight, all the way into the side wall of the smokin grill. |
|
|
| Install the Burn Grate (B). The larger back lip of the grate installs under |
| C | A | the pellet drop chute. The igniter holes should be exposed through |
| the slot in the bottom of the burn grate. The burn grate should be a | ||
2 |
|
| snug fit. |
B |
| 2 . Arched Flavor Guard Level | |
|
| ||
|
| To check for proper height, the bottom of the mounting bracket (B) |
should not be within the pellet drop chute area.
AIf you do need to adjust the bracket, loosen off the two (2) phillips screws, lift the bracket and
The “Arched Flavor Guard” (A) then clips easily over the adjustable mounting bracket (B).
3
A
J |
3 . Grease Can Hanger
The Hanger (A) is designed to drop through the grease spout, from the inside of the barrel.
Lift the tab on the Beverage Can straight up, then the tab simply hooks onto the hanger extending.
Page 5
