IMPORTANT: PLEASE READ BEFORE STARTING YOUR STOVE
The controller on your stove has been fitted with memory. Should you have a power outage or blip, the unit will come back on the setting that you had left it at before.
Before you first plug in a new stove after installation, make sure you have removed all foreign objects from the hopper. When you first plug in the stove, it may possibly power up due to the initial memory test. At this time press the OFF button.
This control is equipped with various functions. As a result, you need to check to make sure you are in the proper burn mode. Once your desired setting is reached, press the START button for operation.
NOTE: Corn stoves DO NOT USE AN IGNITER. The igniter light is the 15 min. delay until the unit reaches the required operating temperature.
To confirm the mode, press and hold the OFF button. When the desired mode flashes as stated below, release the OFF button and press START.
The 3 modes are as follows:
1When the red FEED RATE lights 3 and 4 flash,
that is the High/Low Thermostat Cycle (optional *).
2When the red FEED RATE lights 1 and 2 flash, that is the On/Off Thermostat Cycle (optional *).
3When the red FEED RATE lights 1 and 4 flash, that is the manual function.
You may hit the START button if you are ready with a full hopper of fuel.
* The thermostat is available separately from the stove.
