Voyager 100
Introduction
Thank you for purchasing the Voyager 100 UTP Extender. This product will allow you to place your Monitor and PS/2 Keyboard and PS/2 Mouse up to 100 meters away from your computer.
Product Features
¾Allows a user to control a PC from up to 100 meters (330 feet) away, using a single CAT5, 5e or CAT 6 cable.
¾No additional software is required for operation.
¾Adjustable Video Equalisation - Compensates for loss of image quality due to cable length in several steps with or without extra gain.
¾Fully buffered signals to ensure consistent remote operation of your PC
¾Dual Access allows for an additional keyboard, monitor and PS/2 mouse to be connected through the local unit.
Operation
The Voyager is simple to install, with no software is required. Just connect the units up as described in quick setup system guide and you're ready to work. Switch the computer off before wiring up the units.
Hardware Installation
Before connecting your computer to the Voyager Local unit, please ensure that it is powered off. Connect your console devices to the Voyager remote unit. Note: the Voyager Remote requires power. If your computer does not have a PS/2 mouse or keyboard port, you can use a PS/2 to USB converter
With the constant changes in computers keyboards and mice on the market, it is impossible to guarantee universal compatibility for the Voyager’s keyboard/mouse emulation. The Voyager emulation is compatible with almost all standard PC (Intel/AMD based) BIOS systems.
The local unit is normally powered from the computer through the keyboard connector. Some computers do not supply enough power through the keyboard connector; this necessitates the use of a 5VDC mains adapter on the local unit. The Voyager 100 Local Unit is equipped with a DC jack for the use of an optional power supply. This jack is normally not used, since most computers supply enough power through the keyboard connector.
If you daisy chain the local with other equipment, please use a separate power supply