MODEL MOTTK30 TRADITIONAL MICROWAVE TRIM KIT
INSTALLATION INSTRUCTIONS
Before you begin, read these instructions completely and carefully.
Getting Started
■Remove packaging
Contents
Part Description | Qty |
|
|
Trim Assembly | 1 |
|
|
Base | 1 |
|
|
Mounting Bracket (L/R) | 2 |
|
|
Sheet Metal Screws | 10 |
|
|
Tools Required
1/8” Drill
#2 Phillip Screwdriver
Installing Trim Kit
1. Cut opening in the cabinet face per the following dimensions:
Height: 17” + 1/16”,
Width:
Note: Refer to diagram on the following page. The minimum cabinet depth is 20”. When installing the Microwave and Trim Kit in combination with a Wall Oven or Warming Drawer, please follow the recommendations in the Microwave Installation/ Use & Care Manual.
2.Add adequate platform base support in the bottom of the cabinet for trim kit base to rest on.
3.Mark a centerline on the front edge of the cabinet bottom (Fig. 01).
4.Place trim kit base and align centerline mark to the triangular notch on the front edge of the base (Fig. 02).
5.Drill 1/8” pilot holes in the cabinet using the base as a template and install a screw through the base into the cabinet bottom to prevent the base from shifting (Fig. 03).
Fig. 01
Fig. 02
6.Insert Microwave into opening on top of the base. The Microwave feet should sit in the recesses on the base for correct alignment. The Microwave should be plugged in at this point.
Fig. 03
