
INSTALLING
All ranges must have an
INCLUDED PARTS:
(4) #10 x 2” wood screws,
(1)
INSTALLING THE KIT:
Instructions are provided for wood and cement floors. Any other type of construction may require special installation techniques as deemed necessary to provide adequate fastening of the
WOOD CONSTRUCTION:
(2)SMALL HOLES FOR WOOD INSTALLATIONS
(2)LARGE HOLES FOR CON- CRETE INSTALLATIONS
3/4”
(2)WOOD SCREWS INTO BACK WALL (ALL INSTALLA-
TIONS)
BACK
WALL
| OF |
SIDE | |
RIGHT OR | RANGE |
WALL |
|
Fig. 10
Place the bracket against the back wall, into the right rear corner where the range is to be located. Leave a
gap between the wall (or side of range) and the bracket of 3/4” (see Fig. 10). Drill (2) 1/8” diameter pilot holes in the center of the small holes. A nail or awl may be used if a drill is not available. Fasten the bracket securely to the floor and wall.
CONCRETE OR CEMENT CONSTRUCTION:
Hardware Required:
(2) sleeve anchors, lag bolts, and washers (not provided).
Locate the bracket as described above. Drill the recommended size holes for the hardware. Install the sleeve anchors into the holes and then install the lag bolts through the bracket. The bolts must be properly tightened as recommended for the hardware. Fasten the bracket securely to the floor and wall.
ONCE INSTALLED:
Complete the range installation per the instructions provided with the product. Check for proper installation of the range and
WARNING
ALL RANGES CAN TIP
INJURY COULD RESULT
INSTALL
BRACKET PACKED
INSIDE OVEN
SEE INSTRUCTIONS
Fig. 11
12