Technical Assistance
It is our pleasure to offer assistance if you have any questions regarding your StudioMonitors or their
Service
Service and warranty work on your Definitive loudspeakers will normally be performed by the Definitive Technology dealer from whom you have purchased your loudspeakers. If, however, you wish to return the speaker to us, please contact us first, describing the prob-
lem and requesting authorization as well as the location of the nearest factory service center. Please note that the address given in this booklet is the address of our offices only. Under no circumstances should loudspeakers be shipped to our offices or returned without contacting us first and obtaining return authorization.
Definitive Technology Offices
11433 Cronridge Drive
Owings Mills, Maryland 21117
Phone:
Visit us at www.definitivetech.com
VERY IMPORTANT: SETTING CHANNEL BALANCE AND BASS MANAGEMENT SYSTEMS Dolby Digital and Dolby ProLogic systems and decoders have a critical channel balancing procedure for the left and right front speakers, center channel, rears and subwoofer (if it is hooked up through the LFE or Sub Out low level connection) which must be followed if the system is to perform properly. We have spoken with many system users with problems relating to the overall
sound of their system which could be clearly traced back to improper system balance.
Also note that Dolby Digital decoders have bass management systems (systems which direct the bass to the various channels) which vary from unit to unit. This bass management system must also be properly adjusted. If your StudioMonitor is hooked up with speaker level wires and you are using a separate a subwoofer, your receiver or decoder’s bass management system should be set for “Small” left and right main speakers and “Yes” subwoofer. If you have a PowerMonitor, C/L/R 2300, C/L/R 2500, or C/L/R 3000 center channel, you will usually set your decoder’s bass management center channel setting to “Large” (however, don’t be afraid to experiment). If not, set it to “Small.” If you are using rear surround speakers with very extended low frequency response set the rear channels of your decoder’s bass management system to “Large.” If not, set them to “Small.” If you are using StudioMonitors without a separate subwoofer, set bass manage- ment to “Large” left and right main speakers and “No” subwoofer. (Also, do not be afraid to experiment.) Remember, whatever sounds best to you is correct.
6