TROUBLE SHOOTING Most problems are easily solved if the cause is known.
BEFORE CALLING A SERVICE TECHNICIAN PLEASE CHECK THE
FOLLOWING:
PROBLEM CHECK
The machine will not operate at all. Is there a power failure?
Has the power pad been pressed?
Has the start / hold pad been pressed?
Is there water in the tub?
There is a restricted or no water supply.
If the water flow has not stopped after 20
minutes the fault code IE will be displayed
and a buzzer will sound to indicate a
problem.
See if the tap is open?
Are the water pipes frozen?
Has the water supply been cut off?
Is the inlet filter blocked?
The machine will not drain.
If draining is not completed in a specified
time limit the fault code OE will be
displayed and a buzzer will sound to
indicate a problem.
Is the drain hose blocked or frozen?
Is the drain hose kinked or deformed?
Is the end of the drain hose immersed in
water?
Is there excessive dirt in the drain filter?
The machine will not spin.
If the load is unbalanced the spin cycle will
be interrupted and the machine will stop.
The unbalanced condition may be corrected
by re-filling the tub, rinsing and then
draining. If the unbalanced condition
remains, the fault code UE will be
displayed and a buzzer will sound
indicating a problem.
Is the wash load located all to one side?
Has the machine been installed on an
uneven floor?
Is the lid open? The fault code LE will be
displayed if this is the case.
The Manufacturer strives for continuous improvements. For this reason, the text and
illustrations in this book are subject to change without notice.
Part Number 062 959