Microprocessor Module: Dell Latitude 100L Service Manual
1
3 microprocessor module | see Mini RSL |
4
6. Use a microprocessor extraction tool to remove the microprocessor module.
Installing the Microprocessor Module
NOTICE: Ensure that the cam lock is in the fully open position before seating the microprocessor module. Seating the microprocessor module properly in the ZIF socket does not require force.
NOTICE: A microprocessor module that is not properly seated can result in an intermittent connection or permanent damage to the microprocessor and ZIF socket.
1.Align the
When the microprocessor module is correctly seated, all four corners are aligned at the same height. If one or more corners of the module are higher than the others, the module is not seated correctly.
NOTICE: Hold the microprocessor down while turning the cam screw to prevent intermittent contact between the cam screw and microprocessor.
2.Tighten the ZIF socket by turning the cam screw clockwise to secure the microprocessor module to the system board.
3.Wipe the thermal grease off of the microprocessor
4.Squeeze all of the contents of the thermal grease packet (provided with the kit) on to the microprocessor thermal- cooling assembly.
5.Replace the microprocessor thermal-cooling assembly.
6.Replace the EMI shield.