Replacing the Hard Drive
1. Remove the new drive from its packaging.
Save the original packaging for storing or shipping the hard drive.
2. Replace the hard drive cage and the hard drive bezel.
3. Replace the two screws (one on either side) that secure the hard drive cage and bezel to the hard drive.
4. Slide the hard drive assembly into the bay.
5. Replace the two screws that secure the hard drive assembly to the computer base.
6. Slide the battery into the bay until it clicks into place.
7. Install the operating system for your computer, as needed (see Dell Technology Guide).
8. Install the drivers and utilities for your computer, as needed (see Dell Technology Guide).
Back to Contents Page
1
hard drive cage
2
screws (2)
3
hard drive
4
hard drive bezel
NOTICE: Use firm and even pressure to slide the drive into place. If you use excessive force, you may damage the connector.
NOTICE: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may result in
damage to the computer.