Dell 2450 Installing the Support Tray in the Rack

support.dell.com Dell PowerEdge 2450 Systems - Two-Post Rack Installation 3
DELL CONFIDENTIAL - Preliminary 9/27/01
(Rev. 11/3/98) FILE LOCATION: C:\Dell\docs\2450\2post\81HFFts0.fm
Figure 2. Two-Post Open-Frame Relay Rack 1-U Hole Spacing
Installing the Support Tray in the Rack
CAUTION: The 2-U support tray is designed to support a single
PowerEdge 2450 system. Do not attempt to install any other system in this
support tray. Damage to the system and personal injury may result.
1. Place the support tray into the rack with the bottom of the tray at the marks you
made earlier for the location of the bottom of the installed system.
2. Install four 12-24 x 0.5-inch screws provided to secure the support tray using the
top and the bottom holes on the support tray’s front-mounting flange (see
Figure 3).
An internally threaded stud projecting from the front of the tray flanges accepts
the captive fastener on the front of the PowerEdge server.
3.5 inches (2 U)
1.75 inch (1 U)