Dell 1000W, 1920W/1500W manual Configuring Automatic Start Delay

Configuring Automatic Start Delay

You can configure the load segment to turn on automatically after the utility power returns, if it was shut down by:

SThe button

SAn external command with auto-restart option

SBattery under voltage state

SAutomatic on battery shutdown command

You can specify the restart delay time for each load segment: select zero seconds (0s is the default) to restart immediately, select 1–32767 seconds to delay for the specified time, or select Off.

To set the restart delay times for each load segment:

1Press the button for one second to go to the main menu selection and scroll down to the Settings menu using the button.

2Press the button to enter the Settings menu.

3Use the button to scroll to the Automatic Start Delay option and press the button. The current setting for the option flashes when selected.

4Set the restart delay for one load segment using the and buttons.

5Press the button to confirm.

6Set the restart delay for the other load segment if applicable.

7Press the button to confirm.

NOTE: Load segment On/Off commands issued through the Control menu override the user settings for load segments.

NOTE: A single load segment delay applies to both outlets. However, there is an additional built-in one-second delay between closing segment 1 and 2. The delay is always present when an On command is issued for both segments at the same time.

42 Operation