6.Remove the eight M2.5 x 5-mm screws (four on each side of the display panel) that secure the display panel to the display cover in sequential order.
7.Lift the display panel out of the display cover.
1 | M2.5 x 5-mm screws (8) | 2 | display panel assembly | 3 | display cover |
| | | | | |
8. Remove the four M2 x 3-mm screws (two on each side of the display panel) that secure the brackets to the display panel.
1 | display panel | 2 | bracket (2) | 3 | M2 x 3-mm screws (4) |
| | | | | |
9.Use the pull tab to disconnect the bottom flex-cable connector from the inverter connector.
10.Press inward on the metal clamps on both sides of the top flex-cable connector and gently pull to disconnect the top flex-cable connector from the display locking connector.
1 | top flex-cable | 2 | flex-cable release levers | 3 | back of display panel |
| connector | | (2) | | |
4 | inverter board | 5 | bottom flex-cable | 6 | pull tab on bottom flex-cable |
| | | connector | | connector |
| | | | | |
Replacing the Display Panel
1. Connect the top flex-cable connector to the display connector.
