Back to Contents Page
Power Button Board
Dell™ Inspiron™ 1010 Service Manual
Removing the Power Button Board
Replacing the Power Button Board
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not covered by your warranty.
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the computer.
Removing the Power Button Board
1.Follow the instructions in Before You Begin.
2.Remove the battery (see Removing the Battery).
3.Remove the keyboard (see Removing the Keyboard).
4.Remove the palm rest (see Removing the Palm Rest).
5.Remove the hard drive (see Removing the Hard Drive).
6.Remove the palm rest bracket (see Removing the Palm Rest Bracket).
7.Turn the palm rest bracket over and remove the screw that secures the power button board to the palm rest bracket.
8.Remove the power button cable from its routing.
1 | screw | 2 | power button board |
|
|
|
|
9. Slide the power button board out of the palm rest bracket.
Replacing the Power Button Board
1.Place the power button board on the palm rest bracket.
2.Replace the screw that secures the power button board to the palm rest bracket.
3.Route the power button cable through its routing guide.
4.Replace the palm rest bracket (see Replacing the Palm Rest Bracket).
5.Replace the hard drive (see Replacing the Hard Drive).
