Cable Routing Procedures for Dell™ PowerEdge™ R415 Systems

Figure 10: Disconnecting the Inner CMA Attachment Bracket

Figure 11: Replacing the Outer Power Supply

Disconnected inner

CMA bracket

Section 4: Cabling a PowerEdge™ R415 System Installed in Static Rails

NOTE: The CMA is compatible with the sliding rails only, not the static rails.

1.Follow the instructions contained in the Rack Installation Instructions found in the static rail kit to install the server into a two-post or four-post rack.

2.Install the hook and loop straps provided in the rail kit through the slots in the rear brackets of the rails as described in the Rack Installation Instructions.

3.Connect all applicable cables to the rear of the system and verify that all connections are secure.

Page 9

Page 11
Image 11
Dell manual Cabling a PowerEdge R415 System Installed in Static Rails, Disconnecting the Inner CMA Attachment Bracket