Turning On Server Modules
Figure 10. Turning on a Server Module
Press the power button on each server module, or power on the modules using the systems management software.
NOTE: Make sure that the enclosure is powered on before you power on the server modules.
NOTE: The server modules do not power on until the CMC is properly configured and has fully initialized. It may take an additional two minutes for the server iDRAC to initialize after the chassis is fully powered on.
Installing The Optional Bezel
Figure 11. Installing the Optional Bezel
Install the bezel (optional).
Complete The Operating System Setup
If you purchased a preinstalled operating system, see the documentation associated with the operating system. To install an operating system for the first time, see the installation and configuration documentation for your operating system. Be sure the operating system is installed before installing hardware or software not purchased with the system.
NOTE: See dell.com/support for the latest information on supported operating systems.
8
