MODEL No. 634R SWITCH ON REGULATOR
Suitable for Calor Switch-on (21 mm) Gas Bottle
Connecting the cylinder
ROTATE the plastic cap on the CYLINDER VALVE until the arrow points out through the gap in the valve shroud.
PULL the lanyard out, then upwards. The cap will lift off the valve. Do not use tools. Leave the cap hanging down from the valve while the cylinder is in use.
Assembly on the gas cylinder
Make sure that:
-all taps on the consuming appliace are closed;
-the connecting pipe to the appliance is correctly fitted;
-The
With no flame on, remove the seal cap on the cylinder automatic valve, place the
Note:
OPEN | Handle vertically | |
flame On | ||
|
Handle horizontally
flame Off
CLOSED
fig.3
Operation
Once the
To shut off the gas supply, reverse above procedure; an arrow engraved on the handle indicates the closing direction (fig.3).
Symbols engraved on the bonnet show how to operate the regulator handle. CAUTION: if you are unable, to open the regulator handle, this means that your Quik- on is not correctly connected to the valve. Do not force the handle to open, instead start again the operations described above in 3.
Replacement of a cylinder
Make sure that:
-all taps on the consuming appliance are in the closed position.
-the
Then, dismount the
Do not attempt to carry out this operation with the regulator handle in the open position.
GAS OFF
fig.4
2
1
GAS OFF
fig.5
3