ESPRESSO TROUBLESHOOTING
PROBLEM |
| SOLUTION |
|
|
|
• Machine does not work and switch light does | • | Switch to “ON” position |
not come on | • | Plug in |
|
|
|
• Coffee does not come out | • | Check that the switch is set to “ON “ |
| • Fill the water tank | |
| • Grind coffee more coarsely | |
| • Reduce the quantity of coffee in the filter | |
| • | If you have used your machine for a few |
|
| months, follow descaling instructions on page 9. |
|
|
|
• Coffee comes out too quickly | • | Use finer ground coffee |
| • Increase the quantity of coffee in the filter | |
|
|
|
• Coffee comes out too thick or too slowly | • | Use more |
| • Reduce the quantity of coffee in the filter | |
|
|
|
• Coffee comes out from the | • | Insert the |
|
| right |
| • Clean the edge of the | |
|
|
|
• Coffee in the cup is cold | • | Rinse filters, |
|
| in hot water before making espresso coffee |
|
|
|
• No steam is produced | • | Check that the switch is in the “ON” position |
| • | Check that the steam knob has been turned |
|
| correctly |
| • No water in the reservoir tank | |
|
|
|
• The milk does not foam | • | No milk in the milk container or no water in |
|
| the reservoir tank. |
| • Wait until the “OK” pilot lamp lights. | |
| • Check that the steam knob has been turned | |
|
| |
| • Use fresh milk (not boiled) | |
| • Check that the milk container and the rubber | |
|
| joint have been inserted correctly |
| • Clean the mixer and the rubber joint | |
|
|
|
• The cap will not unscrew | • | Check to make sure there is no pressure in |
|
| the boiler by rotating the steam knob and |
|
| turning the flow regulator to the LIGHT setting. |
|
|
|
|
|
|
13