DeLonghi DW67S manual The rinse aid is released during the final rinse to prevent water

To open the dispenser, turn the cap to the "open" (left) arrow and lift it out.

Pour in rinse -aid into the container is fill (approx . 140 ml) , Being careful not to overfill.

Replace the cap by inserting it aligned w ith "open" arrow and turning i t to the closed (right) arrow.

Your dishwashers are designed to use liquid rinse aids. The rinse aid dispenser is located inside the door next to the detergent dispenser.

The rinse aid is released during the final rinse to prevent water

from forming droplets on your dishes that can leave spots and streaks. It al so improves drying performance by allowing water to "sheet" off the dishes.

Be careful not to overfill the dispenser, because this could cause oversudsing. Wipe away any spills with a damp cloth. Don't forget to replace the cap before you close the dishwasher door.

If you have soft water, you may not need rinse aid for it may cause a white film to develop on your dishes.

Follow the rinse-aid manufactory's recommendations on rinse-aid.

A measured amount of rinse-aid is released during the final rinse. As with detergent, the amount of rinse-aid needed for your dishes depends on the hardness of the water in your area. Too much rinse-aid can result in lather of foaming and cause cloudiness or steaks on your dishes. If the water in your area is very soft, you may not need rinse-aid. If you do,you can dilute the rinse-aid with an equal amount of water.

The rinse-aid dispenser has six or four settings. Al ways start with the dispenser set on " 2 ". If spots and poor drying are problems, increase the amount of rinse aid dispensed by removing the dispenserlid and rotating the dial to "3". If the dishes still are not drying properly or are spotted, adjust the dial to the next higher number until your dishes are spot-free. We suggest you

to set on "4" .(Factory value is "4".)

5