Proceed as follows:
-Remove the filter holder from its hook.
-Dissolve one full
-Place a container under the coffee dispenser lip (with the filter hol- der removed), and another container under the steam arm.
-Bring the lever (7) to the
-Once the sound signal comes on, wait 2 minutes, then dispense one cup of water bringing the lever completely forward (Fig. 6).
-Push the lever back to the
-Repeat the entire procedure once more,ALWAYS following the
steps described in the paragraph “Successive use”.
The decalcifying product remaining in the packet can be stored in a dry place for the next time you decalcify the coffee maker.
Once finished decalcifying the coffee maker, rinse the boiler well with fresh water, then run the machine twice successively with only water so as to remove any trace of acid in the system.
TROUBLESHOOTING
The appliance does not dispense any steam:
- The MAXI CAPPUCCINO device needs cleaning: use a pin to remo- ve any scale build up inside the hole on the MAXI CAPPUCCINO
(3).
-The water level in the boiler tank is insufficient: refill the boiler tank, taking the necessary precautions as described in the paragraph “Successive use” and repeat the steps for dispensing steam.
Coffee leaks out from the sides of the filter holder:
- Probably, too much ground coffee has been placed in the filter, pre- venting the filter holder from being correctly tightened in its seat: repeat the operation, this time using the correct amount of coffee.
-There are residues of ground coffee on the seal of the filter holder seat: clean the seal of the perforated disc with a damp sponge (Fig. 12)
-If the problem persists after you have followed these procedures, contact an Authorised Assistance Centre.
Coffee is not dispensed, is dispensed too slowly, or is dispensed une- venly from the dispenser holes:
-It is possible that slow coffee dispensing depends on a lack of water coming from the perforated disc in the filter holder seat. In fact, it is
9 | Cappuccino and |
| Espresso Coffee Maker |
EC11 Living innovation