DeLonghi EC 152 CD manual Introduction, Instructions for use, Please Note, Check after transport

Introduction

Instructions for use

Thank you for choosing this cofee machine. To get the very best out of your new cofee machine it is advisable to read these instructions before using the appliance. This is the only way to ensure optimum results and ma- ximum safety.

The manufacturer is not liable for damage deriving from the failure to comply with the user instructions.

Please Note:

Keep these instructions carefully. If the appliance should be transferred to other persons, these instructions must accompany it.

Check after transport

After the packaging has been removed, check the integrity of the appliance and the presence of all accessories.

Do not use the appliance in the presence of obvious damage. Contact the De’Longhi Customer Services department, please see enclosed lealet.

Installing the appliance

Attention!

The following safety measures must be complied with when installing the appliance:

•The appliance could be damaged by the penetration of water.

Do not position the appliance near to water taps or sinks.

•The appliance could be damaged if the water it contains freezes. Do not install the appliance in a room where the temperature can fall below freezing point.

•Position the power supply cable in a way that it cannot be damaged by sharp edges or by contact with hot surfaces.

Connecting the appliance

Attention!

Make sure that the electric mains voltage corresponds with that indicated on the rating plate on the base of the appliance.

Only connect the appliance to a correctly installed socket with a minimum rating of 10A and correctly earthed. In the case of incompatibility between the socket and the plug on the appliance, have the plug replaced by a qualiied technician.

•The power supply cable on this appliance must never be replaced by the user as special tools are needed for this operation. Contact an After-Sales Centre authorised by the manufacturer if the cable is damaged or must be replaced, in order to avoid all risks. Please refer to enclosed guarantee lealet for details.

Filling the water tank

1.Open the water tank lid (ig. 1) and then lift the tank to remove it (ig. 2).

2.Fill the tank with fresh water but do not pass MAX level (ig. 3). Re-position the tank by pressing it lightly in a way to open the valve situated on the base of the tank itself.

3.Alternatively, do not remove the tank, just ill it by pouring in water from a jug, be careful of splashes

Attention!

Do not operate the appliance without water in the tank and always ill it when the water is a few centimetres from the bottom.

Please Note: it is normal to ind water in the compartment under the tank; dry using a clean sponge.

7