heater. Plugging heater into a worn outlet /receptacle/ may result in overheating of the power
cord or fire.
17.Do not use an extension cord because the extension cord may overheat and cause a risk offire.However,ifyouhavetouseanextensioncord,thecordshallbe UllistedNo.14AWG minimum size and rated not less than 1 875 watts, ISAMP at 125 V and has to be used only for supplying power to this heater.
18.Be sure that the plug is fully inserted into an appropriate receptacle. Please remember that receptacles also deteriorate due to aging and continuous use: check periodically if signs overheating or deformations are evidenced by the plug. Do not use the receptacle and CALL your electrician.
19.Check that neither the appliance nor the power cable have been damaged in any way during transportation.
20.Before connecting to electric power outlet, check your electrical power supply. It must be 120 volts A.C. (alternating current). The outlet may be 15 amp. or 20 amp. The circuit must be of adequate size and must be protected by fuse or circuit breacker. DO NOT place heater directly beneath electrical receptacle and DO NOT place heater against paper board or low density fiberboard.
DO NOT touch hot surfaces.
DO NOT immerse cord, plug or heater in water or othet liquid, or pour this will cause dangerous electrical conditions and potential electrical shock.
DO NOT obstruct the top or bottom air openings.
Dust and lint on the heating element can obstruct the free flow of air. DO NOT operate when so obstructed.
Operating with air openings obstructed could cause a dangerous condition.
22.Make sure that no pieces of polystyrene or other packaging material have been left into the appliance. It may be necessary to pass over the appliance with a wacuum cleaner.
23.When switching on the appliance for the first time, allow it to run at full power for about 1 hours to get rid of the unpleasant smell. Make sure that the room in which the appliance is located is well ventilated during this operation.
24.It is not advisable for the appliance to be positioned where it is exposed to draughts which might prevent it from working properly.
SAVE THESE INSTRUCTIONS
3
