DeLonghi HMP1500 Functioning and use, Adjusting the thermostat, Frost prevention mode, Warnings

c.No electric cables or other pipes could be damaged during the installation.

d.Keep away from curtains or inflammable materials.

To wall-mount, proceed as follows:

For brick walls use a 15/64" (6 mm) concrete drill bit . For plaster board or false (hollow) walls, it is recommended to use appropriate screws and anchors (not supplied).

1.Before drilling the wall, mark out a template using the mounting bracket respecting the minimum distances as shown in fig. 3.

2.Drill the wall where previously marked, and insert the plastic anchors.

3.Fix the bracket with the 2 screws provided (see fig. 4).

4.Hang the heater on the bracket.

5.Mark out the 2 lower fixing points (fig. 2). Remove the appliance, drill the lower holes and insert the wall anchors.

6.Now, you can hang back the heater to the bracket and fix the lower part of the appliance with the 2 remaining screws.

5. Functioning and use

-Insert the plug into the mains.

-Turn the thermostat knob in a clockwise direction until it reaches the 6 setting.

-Minimum power (750W): turn the function knob to setting “MIN” (the pilot light will light on).

-Maximum power(1500W): turn the function knob to setting “MAX” (the pilot light will light on).

-Switching off: turn the function knob to setting“OFF” and remove the plug.

6. Adjusting the thermostat

Turn the thermostat knob in a clockwise direction until it reaches the maximum setting (6). When the room has reached the desired temperature, slowly turn the thermostat knob counter-clockwise until you hear a click and not beyond. The thermostat will now adjust the set temperature automatically keeping it constant.

7. Frost prevention mode

With the thermostat dial at minimum and the mode selector on "MAX", the appliance maintains room temperature at about 41° F (5°C), preventing freezing with minimal energy consumption.

8. Maintenance

Before carrying out any maintenance, unplug the heater from the mains and wait for it to cool off completely. This heater requires no particular maintenance. It is sufficient to remove the dustwith a soft, dry cloth. Never use abrasive powders or solvents. If necessary remove concentrated areas of dirt with a vacuum cleaner.

9. Warnings

-Do not use the heater in the vicinity of bathtubs, wash basins, showers or swimming pools.

-Never use the heater to dry laundry.

-Never place the power cable on top of the heater while it is hot.

-Only use the heater in an upright position.

-If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

-Do not use your heater with a power strip or extension cord. Overheating of a power strip or extension cord could result in a fire.

-As with any electrical appliance, whilst the instructions aim to cover as many eventualitiesas possible, caution and common sense should be applied when operating your appliance, particularly in the vicinity of young children.

-The appliance is fitted with a tilt-switch which turns the appliance off should it fall over or become unstable. To restart the appliance, simply place it upright again.

The appliance is fitted with a safety auto shut-off device which will switch the appliance off in case of accidental overheating. To reset, disconnect the plug from the power socket for a few minutes, remove the cause of overheating then plug the appliance in again.

WARNING: In order to avoid overheating, never under any circumstances cover the appliances during operation, as this would lead to dangerous overheating.

6