DESCRIPTION OF THE APPLIANCE
The following terminology is used repeatedly on the following pages.
1Power cable
2ON/OFF and (if included) "AUTO" button
3Display
4Button for setting the number of cups (if included)
5Hour setting and increase button
6Minute setting and decrease button
7Timer ON/OFF button
8"AUTO" button (if included)
9"AUTO" pilot light
10ON pilot light
11Warming plate
12Rotating base (if included)
13Carafe for drip coffee
14Measuring spoon
15Filter holder for drip coffee
16Flavor savor
17Permanent filter (if included)
18Drip coffee flavor knob
19Water tank cap
20Removable water tank
21Chlorine filter (if included)
22Chlorine filter holder (if included)
INSTALLATION
•Place the appliance on a working surface away from water taps and sinks.
• Check that the outlet corresponds to the voltage on the appliance rating plate. Connect the appliance to a grounded outlet power socket (minimum rating 10A) only. The manufacturer declines all liability for any accidents due to the incorrect earthing of the appliance.
•Never install the machine in environments where the temperature may reach 0°C - 31°F or lower. The appliance may be damaged if the water freezes.
•If the power cord is longer than the distance required to reach the power outlet, the extra length may be stored inside the machine by pushing the cable inside the corresponding opening.
CHLORINE FILTER (included)
The filter eliminates the taste of chlorine from the water. To install the filter, proceed as follows :
•Remove the chlorine filter from the plastic bag and rinse it in tap water.
•Lift the coffee lid, remove the filter holder from its housing by lifting it upwards (Fig. 1).
•Open the filter holder by pressing the parts marked “PUSH”, and carefully position the filter as shown in Fig. 2.
•Close the filter holder and replace it in its housing, pushing it fully down.
•The chlorine filter must be replaced every 80 cycles, and always after six months of operation.
SETTING THE CLOCK (FIG. 3)
Plug the appliance in. When switched on for the first time, the display will show “12:00” flashing. To set the exact time, proceed as follows:
- Press the “HOUR” button repeatedly until set- ting the current hour.
-Press the “MIN” button repeatedly until setting the current minutes.
Keeping the buttons pressed scrolls the hours and minutes much more quickly.
The time can be set whenever desired.
HOW TO PREPARE DRIP COFFEE
WARNING: the first time coffee is prepared, all the accessories and internal circuits of the machine must be washed as follows:
Make at least two carafes without using ground coffee (following the instructions below).
•Lift the cap and remove the water tank (Fig. 4).
•Fill the tank with fresh, clean water up to the level corresponding to the number of cups of coffee required (Fig. 5).
•Place the tank back in the coffee maker, pressing it lightly. The tank may also be filled without being removed, using the carafe marked with the level indicators (Fig. 6.)
•Open the filter holder by turning it to the left (Fig. 7).
•In versions with a permanent filter, place the filter in the filter holder (Fig. 8). In other versions, use the #4 paper filter.
•Place the ground coffee in the filter, using the measuring spoon supplied, and level evenly (Fig. 9). As a general rule, use a level measuring
5
