DeLonghi KBO3001 manual Service and Customer Care, Electrical Requirements

Cord Clamp

Warning

this appliance must be earthed

Green and Yellow to

Earth

13 amp

Fuse

Brown to

Live

Blue to Neutral

Service and Customer Care

•If the cord is damaged it must, for safety reasons, be repaired by De’Longhi or an authorised De’Longhi service agent.

•Please refer to the enclosed guarantee leaflet for service and assistance details.

Electrical Requirements

The flexible mains lead is supplied connected to a B.S. 1363 fused plug having a fuse of 13 amp capacity.Should this plug not fit the socket outlets in your home, it should be cut off and replaced with a suitable plug, following the procedure outlined below.

Note: Such a plug cannot be used for any other appliance and should therefore be properly disposed of, (having removed the fuse) and not left where children might find it and plug it into a supply socket - with the obvious consequent danger.

If the plug is a moulded-on type the fuse cover must be refitted. If the fuse cover is lost, the plug must not be used until a replacement cover is obtained.The colour of the correct replace- ment fuse cover is that of the coloured insert in the base of the fuse recess or elsewhere on the plug. Always state this colour when ordering a replacement fuse cover.

N.B.We recommend the use of good quality plugs and wall sockets that can be switched off when the machine is not in use. important: the wires in the mains lead fitted to this appliance are coloured in accordance with the following code:

GREEN AND YELLOW	EARTH
BLUE	NEUTRAL
BROWN	LIVE

As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the termi- nals in your plug, proceed as follows:

The wire which is coloured green and yellow must be connected to the terminal in the plug which is marked with the letter E or by

the earth symbol or coloured green or green and yellow.

The wire which is coloured blue must be connected to the termi- nal which is marked with the letter N or coloured black.

The wire which is coloured brown must be connected to the ter- minal which is marked with the letter L or coloured red.

When wiring the plug, ensure that all strands of wire are securely retained in each terminal. Do not forget to tighten the mains lead clamp on the plug. If your electricity supply point has only two pin socket outlets, or if you are in doubt, consult a qualified electrician. Should the mains lead ever require replacement, it is essential that this operation be carried out by a qualified electrician and should only be replaced with a flexible cord of the same size.

Only 13amp replacement fuses which are asta approved to B.S. 1362 should be fitted.This appliance conforms to the Norms EN 55014 regarding the suppression of radio interference.

4 Kettle KBO3001