DeLonghi PAC260 manual Setting up and recommendations, Set Up Instruction, Electrical Connection

PAC260GB 24-04-2003 16:33 Pagina 9

Setting up and recommendations

SET UP INSTRUCTION

For permanent installation place the Pinguino near the outlet opening in wall or window (where it is meant to be used). The diagram below shows the correct way to installl the exhaust hose.

1) Water collects at this point 2) Bend this section 3) Bend this section

fig. 10 NO YES YES

ELECTRICAL CONNECTION

Check that the power supply voltage is 115 V ~ 60 Hz.

Important: if you need to use and extension cord, please be sure to use a heavy duty extension cord (minimum 14 gauge).

Before connecting the Pinguino to power supply, make sure that all switches on the front control panel are in the OFF position.

Connect power cord found in storage compartment at rear of thefig. 11 Pinguino.

FINAL CHECK

In order to obtain the maximum performance from your air-conditioner make sure that:

fig. 12

- Doors and windows of room to be air-condi- tioned are closed (with the exception of tem- porary installation where a partially opened window is necessary).

fig. 14

-Shade the room as far as possible from direct sunlight by drawing curtains and/or lowering blinds or shutters, for economical and efficient air-cooling.

fig. 13

Close the door.

fig. 15

-Ensure that intake and outlet vents (fig. 2 and 3) are not blocked.

-Make sure there are no sources of heat in the room.

9