DESCRIPTION OF PINGUINO PAC 210 U CONTROLS
Timer notches
|
| ON/OFF button |
|
| ON/OFF pilot light |
|
| A |
| B | C |
|
| “Alarm” pilot light |
|
| Timer ON/OFF |
|
| pilot light |
| Timer ON/OFF | Selecting fan |
Thermostat | button | speed button |
SETTING THE TIMER
The programmer/timer, like all clocks, must be set to the exact time. If for example it is 4.00 p.m., turn the dial in a clockwise direction (following the direction of the arrow) until the number 4 is lined up with the arrow pointer (the arrows indicates 4:00 p.m. approximately).
11 | 10 | 9 |
4
arrow pointer
PROGRAMMED MODE
1) Release B timer button.
2)Set the operating times by pushing out the notches on the dial corresponding to the period required (each notch represents 15 mins.).
3)Check that the timer indicates the correct time (see instructions on setting).
Operating time
eg. from 9 to 11 a.m.
11 | 10 | 9 |
|
4
Note:Never turn the dial in an
The timer is in effect, an electric clock and works only if the plug is connected to the power supply. Whenever the plug is disconnected or there is a power failure, the programmer stops (the clock is then “slow”) and must be
The unit can be used in either programmed or
4)Select the desired function as shown in the chart overleaf.
The unit will now switch on and off each day at the selected times.
Note: To override the programmed operating times, simply press the ON/OFF key.
1) B TIMER button must be pressed
2)Select the desired function as shown in the chart on the following page.
N.B: For technical reasons, the temperature is not expressed in degrees but by a line increasing in thickness. We therefore recommend that when starting up the appliance, the thermostat be turned to maximum (thick green line = maximum cold). When the desired temperature has been reached, turn the thermostat slowly away from the maximum cooling position until the appliance switches off. Leave the thermostat in this position. The
After switching the appliance off, wait at least 3 min. before switching on again.
10