DeLonghi TRF1 15 Adjusting the thermostat, Frost protection function, Cleaning and maintenance

Models: TRF1 15

1 6
Download 6 pages 32.62 Kb
Page 4
Image 4
Adjusting the thermostat

Adjusting the thermostat

Leave the thermostat at its highest setting until the room has reached the required temperature.Then slowly turn the thermo- stat slider back until you hear a click.The temperature selected in this way will then be regulated automatically and kept constant by the thermostat.

Frost protection function

With the thermostat slider in the *position and a power selected, the unit maintains the room at a temperature of about 5˚C, pre- venting freezing with minimum energy consumption.

Cleaning and maintenance

Your oil filled raditor is absolutely free from maintenance, fully relia- ble and will give many years of trouble free service. Wipe radiator with soft damp cloth; do not use detergents or abrasives.

If necessary, use a vacuum cleaner to remove any built-up dirt. Some models comes fitted with on anti-dust filter in the ventilation system.

Remove periodically the filter from it seat and clean it (fig.3). Attention: if you do not periodically clean the filter it could happen that the fan stops working. If this occur, proceed as follows:

1.Turn the appliance off.

2.Remove the plug from the mains and let the appliance cool down.

3.Remove the filter and clean it well.

4.Replace the filter.

Important notes

-Do not use your radiator close to bath, wash-basin, shower and swimming pool.

-Do not use your radiator to dry laundry.

-Never place the power cable on top of the radiator while it is hot.

-Only use the radiator in an upright position.

-The heater must be positioned at least 50 cm from furniture or other objects.

-If the power cable has been damaged, it must be replaced by the manufacturer or the technical service centre or by a qualified per- son so as to avoid all risks.

-In order to eliminate the radiator’s “new” smell, set it to maximum power for at least 8 hours when used for the first time. During this operation, the room in which the radiator is located must be ventilated.

-It is perfectly normal for the radiator to make “creacking” sounds when used for the first time. (or in the case of unfrequent use).

-The radiator must not be located immediately below a fixed soc- ket-outlet.

-The body of this radiator is filled with a precise quantity of special

TRF1 15

4

 

Page 4
Image 4
DeLonghi TRF1 15 manual Adjusting the thermostat, Frost protection function, Cleaning and maintenance, Important notes