11
ASSEMBLY
• Do not lift saw without help. Hold it close to your
body while lifting. Keep knees bent and lift with your
legs, not your back.
• Fully assemble saw with leg assembly prior to use.
Leg assembly is an integral and necessary part of the
support structure for this saw.
• Do not modify saw, or create accessories not
recommended for use with this saw.
• Make sure power switch is in “OFF” position before
connecting to power supply.
• Do not connect to power supply until assembly is
complete
• Slotted screwdriver
• Phillips head screwdriver
• 8mm wrench
• 10mm wrench
• 12mm wrench
• 13mm wrench
• 3/8-inch wrench
• 7/16-inch wrench
• 1/2-inch wrench
• 9/16-inch wrench
• 6mm Allen hex wrench
• 5/32-inch Allen wrench
• 3/16-inch Allen wrench

TOOLS REQUIRED FOR ASSEMBLY

(not included)

STAND

1. Connect the two tube legs by inserting
the end of the left leg (A) into the end
of the right leg (B) as shown in Figure 1.
Secure with a M8 x 70mm carriage bolt,
lock washer and nylock nut and tighten.
2. Insert the four open ends of the tube
legs into the leg collars (C) as shown.
Secure ea ch leg with a M6 x 72mm
bolt and nut.
3. Attach the back and front leg support
panels (D) to the legs using four M6 x
10mm self-tapping bolts.
A
Saw Front
DC
B
FIGURE 1
Avoid contact with blade teeth. Keep
blade stored or lowered when possible.