Delta 50-860 instruction manual

MOUNTING THE AIR CLEANER TO THE CEILING O R

O V E R H E A D SUPPORT

W ARNING: THIS TO O L WEIGHS APPROXIMATELY

50POUNDS. MAKE CERTAIN THE UNIT IS SECURE- LY SUPPORTED W H E N MOUNTING TO A CEILING O R OVERHEAD SUPPORT.

1.Locate (4) one inch eye-bolts, and (4) 1/4-20 flange nuts supplied with the unit.

2.Remove four screws, one of which is shown at (C) Fig. 5, from the top of air cleaner (D).

3.Thread one flange nut (E) Fig. 5, approximately half- way onto each eye-bolt (F) supplied, as shown.

4.Thread each eye-bolt (F) Fig. 5, into each of the four holes where screws (C) were removed in STEP 2.

5.Fig. 6, illustrates the four eye-bolts (F) attached to top of air cleaner.NOTE: To adjust the height of the air cleaner, loosen flange nuts (E) and rotate eye-bolts as necessary.Make certain the flange nuts (E) Fig. 6, are tightened down against the surface of the air cleaner after height adjustments are made.

When suspending the air cleaner from the ceiling or other overhead support, make certain the supporting hardware (not supplied) is securely anchored into a wooden supporting structure as shown in Fig. 7.

W ARNING: NEVER SECURE MOUNTING H A R D WARE TO D RY WALL, DROP CEILING TILE/FRAME, OR NON- STRUCTURAL MEMBERS.

F E C

D

Fig. 5

F

E

Fig. 6

Fig. 7

W ARNING: Keep a minimum of seven feet between bottom of air cleaner and the floor surface.

DO NOT use rope, cable or power cord to suspend the unit from the ceiling. We recommend that a chain should be used and rated for a minimum of a 100 lb. working load to firmly support the air cleaner. IMPORTANT:When determining a location to mount the unit, the air cleaner will operate more efficiently when the air flow is unre- stricted. Do not locate the unit in a corner or near any heating or cooling vents.

7