ATTACHING LAMP TO MACHINE
1.Fasten the lamp bracket (A) Fig. 13, to the top cover of the machine, using two M6x1x12mm cap head screws
(B) and 1/4" lockwashers as shown.
2.Peel backing from cord clamps (C) Fig. 13A, and apply one clamp at each of the locations shown. Make certain the lamp cord is routed out of the way of the blade, then secure cord (D) to cord clamps (C) as shown in Fig. 13A.
3.The flexible lamp operates independently of the band saw. To turn the lamp on and off, rotate switch (E) Fig. 13A.
FIRE HAZARD: To reduce the risk of fire, use 40 watt or less, 120 volt, reflector track type light bulb (not supplied). A standard household light bulb should not be used. The reflector track type light bulb should not extend below the lamp shade.
A
B
Fig. 13
E
D
F
C
Fig. 13A
C
FASTENING BAND SAW
TO SUPPORTING SURFACE
The machine must be secured to a supporting surface. Four holes are provided in the band saw base for this purpose, three of which are shown at
(A) Fig. 14.
A
A
Fig. 14
10
