Delta A09733 HOW TO REMOVE THE WHEELS

14-ENG

A09733

HOW TO CLEAN THE WATER

INLET FILTER

This screen ﬁlter should be checked

periodically and cleaned if necessary.

1. Remove ﬁlter by

grasping end and

removing it from

water inlet of pump

as shown.

2. Clean ﬁlter by ﬂushing it with

water on both sides.

3. Re-insert ﬁlter into water inlet

of pump. NOTE: Cone side faces

out.

NOTE: Do not operate pressure

washer without ﬁlter properly installed.

Filter Screen

HOW TO REMOVE THE WHEELS

1. Using a 1/8" hex

head wrench

loosen set screw

in hub collar.

2. Slide hub collar

from axle and

remove the tire.

Contents

Main INSTRUCTION MANUAL CONSUMER SAFETY INFORMATION IMPORTANT SAFETY INSTRUCTIONS SAFETY GUIDELINES - DEFINITIONS RISK OF EXPLOSION OR FIRE (continued) HAZARD RISK TO FLUID INJECTION RISK TO BREATHING WHAT CAN HAPPEN HOW TO PREVENT IT RISK OF BURN WHAT CAN HAPPEN HOW TO PREVENT IT CHEMICAL RISK OF RISK OF ELECTRICAL SHOCK SURFACES RISK OF HOT ELECTRICAL SHOCK RISK OF UNSAFE OPERATION RISK OF INJURY FROM SPRAY ASSEMBLY INSTRUCTIONS CARTON CONTENTS Page OPERATING INSTRUCTIONS BASIC ELEMENTS OF A BASIC ELEMENTS OF AN ENGINE PRESSURE WASHER OPERATING FEATURES PRESSURE ADJUSTMENTS PRESSURE WASHER TERMINOLOGY * TO USE SPRAY WAND READ AND UNDERSTAND ALL WARNINGS BEFORE STARTING UNIT HOW TO APPLY CHEMICALS AND CLEANING SOLVENTS STARTING SHUTTING DOWN MAINTENANCE ENGINE PUMP NOZZLE CLEANING HOW TO CLEAN THE WATER INLET FILTER HOW TO REMOVE THE WHEELS STORAGE ENGINE PUMP TROUBLE SHOOTING GUIDE PROBLEM CAUSE CORRECTION PROBLEM CAUSE CORRECTION WARRANTY