14.IMPORTANT: Make certain the spindle taper (O) Fig. 14, and tapered hole in chuck (P) are clean and free of any grease, lacquer or rust preventive coatings. NOTE: Household oven cleaner can effectively remove any sub- stance from the chuck; however, carefully follow the manufacturer's safety rules concerning its use.
15.IMPORTANT: OPEN THE CHUCK JAWS AS WIDE AS POSSIBLE MAKING SURE THE CHUCK JAWS ARE INSIDE THE CHUCK.
16.Holding chuck on taper of spindle, tap with a soft tip hammer (Q) or a block of wood and hammer to set chuck, as shown in Fig. 15.
To avoid damage to the chuck, NEVER drive the chuck onto the spindle with a metal hammer.
17.Thread the three pinion shaft handles (R) into the three holes located in the pinion shaft hub (S), as shown in Fig. 16.
O
P
Fig. 14
Q
Fig. 15
S
R
R
Fig. 16
13
