CME-USB01 USB Interface for VFD-E Series Instruction Sheet
Please thoroughly read this instruction sheet before installing option cards and putting them into use.
The content of this instruction sheet may be revised without prior notice. Please consult our distributors or download the most updated version at http://www.delta.com.tw/industrialautomation/.
XLayout
USB Card
ZSpecification
Environmental
YInstallation
Operating Temperature
Storage Temperature
Ambient
Humidity
Installation Altitude
Vibration
Less than 90%RH
Below 1000m
Less than 20Hz: Maximum 9.81 m/s2 (1G);
20 ~ 50Hz:
Maximum 5.88 m/s2 (0.6G)
Make sure that the AC Motor Drive is powered off before operation. DO NOT insert or remove the card when the AC Motor Drive is powered on.
Please mount the extension card as shown and fix it with the screw packed with the card.
Screw torque:
Maximum
USB Cable
USB Type B to | USB Type A to PC |
NOTE
Refer to Chapter 5: Parameters 9 (Group 9) in the user manual for further details.
NOTE
Always use this product in a clean indoor location free from dust, corrosive gas and liquid.
Inputs/Outputs
| Baud Rate | Supports 4800, 9600, 19200, |
| 38400, 57600 bps. | |
|
| |
| USB | USB v1.1 |
| Specification |
[Notes
Please use shielded wires to avoid interferences and connect the shield to ground.
To avoid interference, route the extension card wires separately and as far away (at least 15cm) as possible from other control wires, motor wires and power wires, etc. Where these wires must cross each other, please make sure they are at a 90o angle.
Always use and operate this product within the limit of its specifications.
