Manuals / Delta Electronics / Computer Equipment / Power Supply

Delta Electronics Series H48SV For Negative Remote On/Off Logic, For Positive Remote On/Off Logic

Models: Series H48SV

1 14

Download 14 pages 30.31 Kb

Page 4

Image 4

ELECTRICAL CHARACTERISTICS CURVES

For Negative Remote On/Off Logic

Figure 4: Turn-on transient at full rated load current (resistive

load) (2 ms/div).Vin=48V. Top Trace: Vout; 2V/div; Bottom

Trace: ON/OFF input: 5V/div

For Positive Remote On/Off Logic

Figure 5: Turn-on transient at zero load current (2 ms/div).

Vin=48V. Top Trace: Vout: 2V/div; Bottom Trace: ON/OFF input: 5V/div

Figure 6: Turn-on transient at full rated load current (resistive

load) (2 ms/div).Vin=48V. Top Trace: Vout; 2V/div; Bottom

Trace: ON/OFF input: 5V/div

Figure 7: Turn-on transient at zero load current (2 ms/div).

Vin=48V. Top Trace: Vout: 2V/div; Bottom Trace: ON/OFF input: 5V/div

Page 4

Image 4

Delta Electronics Series H48SV manual For Negative Remote On/Off Logic, For Positive Remote On/Off Logic

Contents

FEATURES OPTIONSAPPLICATIONS DATASHEET DSH48SV0502008102007TECHNICAL SPECIFICATIONS INPUT CHARACTERISTICSOUTPUT CHARACTERISTICS DYNAMIC CHARACTERISTICSELECTRICAL CHARACTERISTICS CURVES For Positive Remote On/Off Logic For Negative Remote On/Off LogicELECTRICAL CHARACTERISTICS CURVES ELECTRICAL CHARACTERISTICS CURVES Figure 8 Output voltage response to step-change in load current 50%-75%-50% of Imax dI/dt = 0.1A/µs.Vin=48V. Load cap 10µF, tantalum capacitor and 1µF ceramic capacitor. Top trace Vout 100mV/div, Bottom trace Iout 5A/div. Scope measurement should be made using a BNC cable length shorter than 20 inch. Position the load between 51 mm and 76 mm 2 inches and 3 inches from the moduleELECTRICAL CHARACTERISTICS CURVES Copper StripSCOPE LOADELECTRICAL CHARACTERISTICS CURVES OUTPUT VOLTAGEVin=48V LOAD CURRENT ATHERMAL CURVES NO HEATSINK Figure 18 Output current vs. ambient temperature and airFigure 19 Power dissipation vs. ambient temperature and air velocity V in=75VSafety Considerations Soldering and Cleaning ConsiderationsDESIGN CONSIDERATIONS Input Source ImpedanceFEATURES DESCRIPTIONS Over-Temperature ProtectionOver-Current Protection Over-Voltage ProtectionFEATURES DESCRIPTIONS CON Output Voltage Adjustment TRIMTHERMAL CONSIDERATIONS Thermal Testing SetupThermal Derating Pin Specification MECHANICAL DRAWINGName FunctionWARRANTY PART NUMBERING SYSTEMMODEL LIST EFF @ 100% LOAD