Deltaco 50-868 instruction manual Using the Remote Control, Operations

USING THE REMOTE CONTROL

To reduce the risk of fire or electric shock, do not use this unit with any solid-state speed control device. The remote control provided with this unit is not considered a solid-state device.

The Air Cleaner is equipped with a REMOTE CONTROl

(A) Fig.7A. NOTE: The remote requires two	(2) AAA
batteries (not supplied). Battery housing is	located

B

C

D

A

H

G F

E

I

inside the back cover.

Notice that the remote control has three control buttons (Fig. 7A): TIME (B), ON/OFF (C), and SPEED (D). These buttons correspond to the LED sensor panel on the rear of the machine (I) Fig. 7B. NOTE: When the machine is connected to the power source, a green light (E) will be activated on the panel.

To activate the blower unit, press the “ON/OFF” button

(C)Fig. 7A. The machine will begin in the default speed of Low or “L” on the sensor panel. Press the SPEED but- ton once, and the machine will run at the high (or “H” level). Press the SPEED button again, and the machine will run at the medium speed (or “M”). Press the SPEED button a third time, and the machine will return to the Low Speed mode.

To turn the machine off, press the “ON/OFF” button (C) Fig. 7A.

Fig. 7A Fig. 7B

The 50-868 Dust Collector provides a timer that can be set by remote control. (B) Fig. 7A.

When the TIME button (B) Fig. 7A is pressed on the remote control, the machine will run for 1/2 hour. (An LED light will show up on the sensor panel (F) Fig. 7B). Pressing the TIME button again will set the machine to run for one hour. Notice that the light on the sensor panel has now moved to the 1H location (G) Fig. 7B. When the TIME button is pressed a third time, the machine will run for 90 minutes. At this point, two lights will appear - one under the 1H location (G) and one under the 1/2H location (F) indicating an hour and a half.Continue this process for up to 7 1/2 hours of run time.

All of these actions can be manually controlled by using the buttons on the sensor panel (I) Fig. 7B.

OPERATIONS

1.NOTE: The air cleaner may produce a slight odor for the first few hours of operation due to the protective coating which is applied to internal components. This odor will dissipate and should be disregarded. IMPORTANT: Never operate the air cleaner without air filters in place.

The Delta 50-868 air cleaner can be used in

a.bench-top sanding applications.

b.circular saw applications

c.dry wall applications

d.shop cleaning applications

e.floor sanding applications.

f.any other application where non-metallic dust is a factor.

8