ENGLISH
43
ENGLISH
Advanced Setup – Part 2Advanced Setup – Part 2
Set the volume of the various speakers so that the sound output from
the speakers and the subwoofer seems to have the same volume
level.
Press FFGGto set, then press HH.
When “Auto” mode is selected:
Press FFGGto adjust the volume.
•Test tones are output automatically, in the order shown below.
Auto:
Adjust the level while listening to the test tones produced
automatically from each speaker.
Test tones are automatically emitted from each speaker.
Manual:
Adjust with the speaker from which the test tone is output
switched manually.
FL
SW
CFR SR
SBL
SL
SB
SBR
Setting the Test Tone
The volume can be adjusted within the range –12 dB to +12 dB.
When “Manual” mode is selected:
Press DDHHto select the speaker, then press FFGGto
adjust the volume.
Press ENTER to finish the Test Tone setting.
2
3
-1
3
-2
4
(2 speakers)
(1 speaker)
¢Adjusting the test tone using the remote control
unit
Adjustment of the test tones using the remote control unit is only
possible in the “Auto” mode and only valid in the STANDARD (Dolby/
DTS Surround) mode. The adjusted levels are automatically stored for
the different surround modes.
Press [TEST TONE].
•Test tones are output from the different speakers.
Press [TEST TONE].
Press FFGGto adjust the volume.
1
2
3
•To adjust the channel level separately for the different play modes
after setting the channel level, perform the operation on page 29.
Press FFto select “Yes”.
1
Press ENTER the setting and switch to the Input Setup.
5
1 7 T . T O N E Y e s <
1
T . T o n e A u t o >
2
T E S T T O N E O N
3
A U T O - F L
5