Advanced Setup – Part 1 Advanced Setup – Part 1
40
ENGLISH
ENGLISH
4 A u t o S u r r . O N
3
2 P . O n L A S T
3 M u t e F U L L
1 L i m i t - 1 0 d B
2
Setting the Auto Surround Mode
Set whether or not to store the surround mode last played for the
input signal.
The surround mode used at last for the three types of input signals
shown below is stored in the memory, and the signal is automatically
played with that surround mode the next time it is input.
qAnalog and PCM 2-channel signals (STEREO)
w2-channel signals of Dolby Digital, DTS or other multi-channel
format (DOLBY PLIIx Cinema)
eMulti-channel signals of Dolby Digital, DTS or other multi-
channel format (DOLBY/DTS SURROUND)
Default settings are indicated in ( ).
Press ENTER to enter the setting and switch to the
Speaker Setup.
2
Press FFGGto set.
1
4 A u t o S u r r . O F F
1
2
1
O p t i o n S e t u p
Option Setup
Setting the Volume Control
This sets the volume level of output.
Press DDHHto select the item, then press FFGGto set.
Volume Limit:
Set the volume’s upper limit.
•0 dB, –10 dB, –20 dB:
The volume cannot be increased above the selected levels.
•OFF:
If you do not want to set a volume limit, select “OFF”.
In this case, the volume can be set to the AVR-1507’s maximum
volume (output) level of +18 dB, which is extremely loud.
2
Muting Level:
Set the level of volume attenuation in the mute mode.
•FULL:
The volume is fully muted.
•–40 dB, –20 dB:
The volume is lowered 40 dB or 20 dB from the current level.
Power On Volume Level:
•LAST:
The volume set when the AVR-1507 was last used is stored in the
memory and set when the power is turned on.
•– – – (Mute):
The volume is always muted when the power is turned on.
•–80 dB ~ +18 dB:
Set the volume level when the power is turned on.
You can adjust the volume level within the range of –80 to +18 dB.
Press ENTER or HHto enter the setting and switch to
the Auto Surround Mode setting.
3
Press FFGGto select “3. Op”, then press ENTER.
1