Advanced Setup – Part 2

2Parameters

Large:

Select this when using speakers that have sufficient ability to reproduce bass sound below the frequency set for the crossover frequency mode.

Small:

Select this when using speakers that do not have sufficient ability to reproduce bass sound below the frequency set for the crossover frequency mode. When this is set, bass sound with a frequency below the frequency set for the crossover frequency mode is sent to the subwoofer.

None:

Select this when no speakers are installed.

Yes / No:

Select “Yes” when a subwoofer is installed, “No” when a subwoofer is not installed.

2sp / 1sp:

Set the number of speakers to be used for the surround back channel.

If the subwoofer has sufficient low frequency playback capacity, good sound can be achieved even when “Small” is set for the front, center and surround speakers.

Setting the Delay Time

Input the distance between the listening position and each speaker to set the delay time for the surround playback.

Preparations:

Measure the distances between the listening position and the speakers.

FL Center FR

Subwoofer

Listening position

SLSR

SBL SBR

1 Press the CURSOR D or H button to select “Delay Time” at the “Speaker Setup” menu, then press the ENTER button.

• The “Delay Time” screen appears.

2 Press the CURSOR D or H button to select the speaker to be set.

3 Press the CURSOR F or G button to set the distance between the speaker and the listening position.

The distance changes in units of 1 foot each time the button is pressed. Select the value closest to the measured distance.

If “Yes” is selected for “Default”, the settings are automatically reset to the default values.

The difference in distance for the various speaker settings must not be greater than 20 ft.

4 Press the ENTER button to enter the setting.

• The “Speaker Setup” menu appears.

ENGLISH

Advanced Setup – Part 2

Setting the Channel Level

•Use this setting to balance the playback levels in different channels and make them appear equal.

•From the listening position, listen to the test tones produced from the speakers to adjust the level.

•The levels can also be adjusted directly from the remote control

unit ( page 47).

1 Press the CURSOR D or H button to select “Channel Level” at the “Speaker Setup” menu, then press the ENTER button.

• The “Channel Level” screen appears.

2 Press the CURSOR F or G button to select “Auto” or “Manual”.

Auto:

Adjust the level while listening to the test tones produced automatically from each speaker.

Manual:

Select the speaker from which you want to produce the test tone to adjust the level.

3 Press the CURSOR D or H button to select “TEST TONE Start”, then press the CURSOR F button to select “Start”.

46

ENGLISH