ENGLISH
Connecting Other Sources
Connecting the antenna terminals
An FM antenna cable plug can be connected directly.
| AM loop antenna |
Direction of broadcasting station | (Supplied) |
FM antenna |
|
75 Ω /ohms Coaxial cable
FM indoor antenna
(Supplied)
AM outdoor antenna
Ground
Connecting Other Sources
Connecting the iPod®
When using an iPod, you must connect the DENON original iPod Dock and the DOCK CONTROL jack on the
The diagram below shows an example of connections for when the iPod is assigned to the VDP terminal.
For instructions on assigning the iPod to a specific terminal, see | iPod | ||
“Setting the iPod Assignment” ( | page 47). | ||
| |||
For instructions on playing the iPod, see “Playing the iPod” ( 
page 39).
A
R 
R 
L 
L 
AUDIO OUT
G
2AM loop antenna assembly
Connection of AM antennas
• The optional standard iPod Dock is DENON
12
Remove the vinyl tie and take out the connection line.
4
a. With the antenna on top any stable surface.
Mount
b. With the antenna attached to a wall.
Connect to the AM antenna terminals.
3
Bend in the reverse direction.
1. Push the | 2. Insert the | 3. Return the |
lever. | conductor. | lever. |
NOTE:
•Do not connect 2 FM antennas simultaneously.
•Even if an external AM antenna is used, do not disconnect the AM loop antenna.
•Make sure the AM loop antenna lead terminals do not touch metal parts of the panel.
Connecting the
This is a control expansion terminal for factory use only. Consult you dealer for details.
Perform the following operation before using an external controller connected to the
1. Press the ON/STANDBY button on the main unit and set the unit to the operating mode.
2. Perform the operation to turn off the power from the external control.
3. Check that the product has been set to the standby mode.
Installation hole Mount on wall, etc.
After checking the above, check the connections of the external controller. Operation is possible.
20
ENGLISH