Denon AVR-4806 3 4, 1 5, 2, 7 8, 6 9

Before Using
•The following buttons are used to operate the XM radio.
2Checking the XM signal strength and Radio ID
3Set the input source to “TUNER”.
4Press the TUNER button on
the remote control unit to
select the TUNER mode.
(Main unit) (Remote control unit) (Remote control unit)
1
5Watching the display, press the BAND button
to select the XM mode.
(Remote control unit)
Press the POWER switch to turn on the main
unit.
2Press the ON/STANDBY switch on the main
unit or ON button on the remote control unit.
7
8
6
9Press the TUNING ªbutton to select channel 0
(XM000).
•The Radio ID is displayed.
Press the STATUS button on the main unit
until “SIGNAL” is displayed.
•The display changes as shown below according to
the receiving condition.
Press the STATUS button until the XM channel
(ex.XM001) is displayed.
Adjust the antenna location until
“SIGNAL:GOOD” is displayed.
2
ConditionDisplay
GOOD Signal strength is good
MARGINAL Signal strength is marginal
WEAK Signal strength is poor
NO Loss of the signal
ON/STANDBY STATUS
POWER
FUNCTION
CURSOR
F
CURSOR
H
CURSOR
D
CURSOR
G
ENTER
TUNER
BAND
ENTER
CURSOR
F
TUNING
•
TUNING
ª
CURSOR
G
CURSOR
CURSOR
H
D
XM000 RADIO ID
Radio ID
TUNER
(Input source)
ON
SOURCE